Much had been rumored about the hidden port in the Apple Watch strap connector recess, and much more had been speculated about its usefulness or components. Indeed, by removing the cover, we can see access to a kind of connection that employees would use for diagnostic tasks corresponding to the Aplpe Watch in the Apple Store or technical assistance services. Today we are going to give you a sample of what it is and how to access it.
The port is made up of a six-wire brass contact, which is understood to be intended for helpdesk technicians, and could provide access to the Apple Watch operating system and thus also install demo software on demo units. in Apple stores. We are going to detail a small tutorial on how to access this six-pin port using only a sewing needle. However, we remind you that this action is not very advisable because it could affect the sealing of the Apple Watch and therefore void the warranty.
- We remove the Apple Watch straps.
- We insert the sewing needle into the small hole that can be seen.
- Do not press the needle as you would to remove the SIM, the closure system is not the same. It will be enough to exert a little pressure while we pry to remove the cover by angling the needle a little.
This little cap will come off with amazing ease, but don't worry, putting it back on will be just as easy So just worry about not losing it. In case it did not seem illustrative enough, I also leave you a video-tutorial from the guys from Reserve Strap.
Once again I reiterate the possibility that the warranty is voided in the Apple Watch by manipulating it, in addition to affecting the protection of the entry of water into it. However, it is curious how little is said about this port and the secrecy they are maintaining about it. However, and in view of its form and function, this port is certainly not intended for any type of third-party accessory.