A few months ago, some analysts predicted that the iPhone 6s was going to be thicker than the current model. The reason that was given in the beginning for this increase was the arrival of the pressure recognition system, currently known as Force Touch but that is expected to change its name on September 9, which adds one more sheet to the screen panel. Later, Unbox Therapy verified that a different material had been used than that used in the iPhone 6 and yesterday it was possible to measure a mounted device that confirms that the iPhone 6s will be thicker, but also a little taller and wider.
As you can see in the previous image, the iPhone 6s will have a measurement of 7,08mm thick. This is a measurement of 0,18mm, which would be less than a fifth of a millimeter. A person with good eyesight could appreciate the difference if we made two lines with the difference mentioned on a paper with a marker, but it is not a difference that can be seen with the naked eye in a fully assembled device, and less if it is totally curved by all its ends. In the case of the iPhone 6s Plus, the thickness would be 7,28mm.
But, in addition to the expected thickness of more, the iPhone 6s will also be taller and wider. With respect to height, the new model will be 138,19 mm, also 0,18mm more than the previous model which had a height of 138,1mm. In the width is where there is more difference, increasing 0,68mm the measure of last year's model. In total, the new model will be 67,88mm wide, up from just 67mm from last year.
These extra tenths of a millimeter in all measurements seem to have their reason in avoiding the bendgate. In addition to using 7000 series aluminum, they have also added more material, which allows the bare case to withstand three times the pressure that the iPhone 6 case supports. On the other hand, if we have an accessory for current models, half a millimeter of more than its Width should not be an impediment to using the accessories we already have, although Spiegen has already announced that it has specific covers ready for the new models.
Good news, personally I am glad that it has "fattened" a little more to give more resistance, I wish the camera was flush without protruding (although that I suppose that even the i7 I do not think it will happen) since those "thousandths" thicker I don't think they were enough ...
It's not for nothing .. But nobody has updates in the AppStore and they are super slow ???? I've been trying to install apps or updates all week and a 50mb app can take 10-20 minutes to update or download.
Yes Jose, I've also been noticing the same thing all week ...